diff options
Diffstat (limited to 'Documentation/pretty-formats.txt')
| -rw-r--r-- | Documentation/pretty-formats.txt | 28 |
1 files changed, 18 insertions, 10 deletions
diff --git a/Documentation/pretty-formats.txt b/Documentation/pretty-formats.txt index 47b286b..d433d50 100644 --- a/Documentation/pretty-formats.txt +++ b/Documentation/pretty-formats.txt @@ -173,12 +173,17 @@ endif::git-rev-list[] - '%Cblue': switch color to blue - '%Creset': reset color - '%C(...)': color specification, as described under Values in the - "CONFIGURATION FILE" section of linkgit:git-config[1]; - adding `auto,` at the beginning will emit color only when colors are - enabled for log output (by `color.diff`, `color.ui`, or `--color`, and - respecting the `auto` settings of the former if we are going to a - terminal). `auto` alone (i.e. `%C(auto)`) will turn on auto coloring - on the next placeholders until the color is switched again. + "CONFIGURATION FILE" section of linkgit:git-config[1]. + By default, colors are shown only when enabled for log output (by + `color.diff`, `color.ui`, or `--color`, and respecting the `auto` + settings of the former if we are going to a terminal). `%C(auto,...)` + is accepted as a historical synonym for the default (e.g., + `%C(auto,red)`). Specifying `%C(always,...) will show the colors + even when color is not otherwise enabled (though consider + just using `--color=always` to enable color for the whole output, + including this format and anything else git might color). `auto` + alone (i.e. `%C(auto)`) will turn on auto coloring on the next + placeholders until the color is switched again. - '%m': left (`<`), right (`>`) or boundary (`-`) mark - '%n': newline - '%%': a raw '%' @@ -199,8 +204,11 @@ endif::git-rev-list[] than given and there are spaces on its left, use those spaces - '%><(<N>)', '%><|(<N>)': similar to '% <(<N>)', '%<|(<N>)' respectively, but padding both sides (i.e. the text is centered) --%(trailers): display the trailers of the body as interpreted by - linkgit:git-interpret-trailers[1] +- %(trailers): display the trailers of the body as interpreted by + linkgit:git-interpret-trailers[1]. If the `:only` option is given, + omit non-trailer lines from the trailer block. If the `:unfold` + option is given, behave as if interpret-trailer's `--unfold` option + was given. E.g., `%(trailers:only:unfold)` to do both. NOTE: Some placeholders may depend on other options given to the revision traversal engine. For example, the `%g*` reflog options will @@ -213,8 +221,8 @@ If you add a `+` (plus sign) after '%' of a placeholder, a line-feed is inserted immediately before the expansion if and only if the placeholder expands to a non-empty string. -If you add a `-` (minus sign) after '%' of a placeholder, line-feeds that -immediately precede the expansion are deleted if and only if the +If you add a `-` (minus sign) after '%' of a placeholder, all consecutive +line-feeds immediately preceding the expansion are deleted if and only if the placeholder expands to an empty string. If you add a ` ` (space) after '%' of a placeholder, a space |